Mersen STP208YN07M
Comparison CITEL DS74US-120Y
Surge Protective Device (SPD)

CITEL DS74US-120Y Surge Protector	Mersen STP208YN07M Surge Protector
Intended Application	System
System Voltage	208/120Vac
Number of Phases	3-Phase
Conductors	3 Wire
Configuration	WYE

PRODUCT COMPARISON TABLE

This page collects publicly available data from ul.com and assembles a side by side
reference table for a convenient product cross reference.

Manufacturer
UL File #	E326289	E210793
Model	DS74US-120Y	STP208YN07M
Product Image
UL.com Ratings	UL CARD	UL CARD
UL APPROVAL	LISTED	LISTED
UL MARK
SPD Type	1	1
Volt (V)	208/120	120/208
AC/DC DC PV	AC	AC
Phase	3Y	3Y
Amps (A)	n/a	n/a
Ambient Min (C)	-40	-40
Ambient Max (C)	85	85
Mode
	L-L L-N L-G NG	L-L L-N L-G N-G
VPR (Vpk)
L-L L-N L-G N-G	1200 800 1200 700	1200 600 1200 600
MCOV
L-L L-N L-G N-G	300 150 300 150	360 175 175 175
In (kA)	20	20
SCCR (kA)	200	200
Additional Data Sheet Ratings
Protection Circuit	Multi-MOV Technology	-
Leakage Current	Yes	Yes
TOV Optimized	No	No
Diagnostics	Visual Fault Indicator & Remote Contacts	-
Environmental Rating	NEMA 2 (IP20)	-
Network Configuration	3PH, 4W+G, WYE	WYE
Modes of Protection	Common Mode Differential Mode	Common Mode Differential Mode
Warranty	10-years	2-years

Determining the acceptability of an SPD for your UL equipment for UL 508A Control Panels and All Other UL Listed Equipment

The UL inspector will first consider the SPD type when determining it’s acceptability for a given application or piece of equipment. This will include UL 508A as well as all other UL Listed equipment. The first level compliance is based on the UL Approval (LISTED or RECOGNIZED) of the SPD or UL SPD Type and it’s Suitable Ratings. This means that it has to meet all safety, performance, environmental and electrical system ratings of the application. If any of these criteria are not fully met, it will require a Procedure Description, a File Update and/or Additional Testing. These actions will require additional costs that may be substantial. For this reason, it is in the interest of the specifier to use UL LISTED SPD’s to eliminate any uncertainty or to make sure the UL RECOGNIZED SPD is selected at the time of UL submittal of the equipment.

Approval Considerations Table based on UL SPD Type

UL Mark	UL1449 SPD Type	Suitable Ratings	Procedure Described	File Update or Additional Testing	Notes
	1 2	Yes	No	No	The only requirement is that the SPD must match electrical and environmental ratings of the UL 508A Control Panel. A UL field inspection of the control panel with the SPD installed is required as a part of a standard follow-up service visit.
	1CA 2CA 4CA 5	Yes	Yes	Yes	Yes – All UL recognized SPD’s require a UL engineering evaluation of the SPD’s existing UL1449 E–file. This will result, at a minimum, in a cost to update the UL file and may also require testing that would result in additional costs.

10108 USA Today Way Miramar, FL 33025 USA	Contact us to develop a surge mitigation solution for your application
www.citel.us	Where to purchase Citel SPD's